Join our mailing list!







You are here: Home > Engine Parts > Clutch Components > Tools & Hardware
Sort By:
Page of 1
Throw Out Super Clips Thru 70 Each
Our Price: $3.95

H.D. Throw-Out Bearings should be installed whenever replacing your Pressure Plate & or Disc.  Super clips make sure everything stays in its place.
EMPI 5302-K - CLUTCH PILOT TOOL ONLY - FITS T1 (BUG ENGINES) EARLY T2 (BUS ENGINES)
Our Price: $4.95

CLUTCH PILOT TOOL ONLY - REQUIRED TO INSTALL CLUTCH!
EMPI 5759 - LIFTER RETAINING CLIPS - PAIR
Our Price: $4.95

Clutch Installation Kit
Our Price: $5.95

Grade 8 bolts, wavy washers & a clutch pilot tool complete any VW Clutch installation.
EMPI 17-2817 - HEIM END 3/8" - 24 THREADS - 3/8" BALL - FOR EMPI CLUTCH SLAVE - EACH
Our Price: $8.95

IT IS IMPERATIVE THAT THE CLUTCH SLAVE BE MOUNTED IN A LEVEL POSITION!
BRACKETS & HEIM ENDS MAKE IT EASIER TO MOUNT WITH SMOOTHER ACTION!

BRACKETS AVAILABLE.
EMPI 5003 - UNIVERSAL FLYWHEEL LOCK 6 VOLT / 12 VOLT
Our Price: $9.95

CAN BE USED ON 6 OR 12 VOLT FLYWHEELS.
GLAND / AXLE NUT SOCKETS, 46MM, 3/4 DRIVE - EMPI 5770
Our Price: $9.95

REMOVE GLAND NUTS OR AXLE NUTS WITH THIS SOCKET AND BREAKER BAR!

THIS ITEM CAN BE USED ON AN AIR GUN HOWEVER ALWAYS USE A 4 FT BREAKER BAR WHEN FINISHING OFF TO ENSURE PROPER TORQUE.  AIR GUN WILL NOT PROVIDE ENOUGH TORQUE!

YOU SHOULD ALSO USE RED LOC-TITE ON EITHER AXLE NUT OR GLAND NUT TO ENSURE TORQUE.
EMPI 5748 - 36MM AXLE NUT / GLAND NUT TOOL
Our Price: $12.95

REMOVE REAR AXLE NUTS OR GLAND NUTS WITH THIS TOOL & YOUR 1/2" BREAKER BAR OR SLUDGE.

ITEM ALSO KNOWN AS AXLE NUT WACK TOOL!  FOR T1 NOT T2.  T2 IS 46MM!
EMPI 5004 - CRANKSHAFT & FLYWHEEL DRILL FIXTURE TOOL
Our Price: $23.95